Mountain Project Logo

Kyle O

32 years old · Male

Member Since
Dec 7, 2019
Last Visit: 1 day ago
4,485 Points
Point Rank: #236 DetailsDrop down

Kyle is in the Partner Finder
Best Times to Meet: Mon/Wed/Fri/Sat/Sun
Likes Trad, Sport, Tr, Gym, Boulders
Leads Follows
Trad 5.10d 5.11d
Sport 5.11a 5.11d
Ice WI3 WI5
Mixed M4 M8
Boulders V4
More Info


Comments View All 485

Oct 13, 2025
Thank you, Steve! View Comment
Oct 2, 2025
The bottom of the eye of the bolt should be flush with the rock. These glue-ins are not pounded in quite fa… View Comment
Sep 16, 2025
Hmm, I don’t recall a 5.9 move to get to that bolt, but I don’t doubt it. You can get a funky BD #4 or 5 pl… View Comment
Sep 15, 2025
For the start of P3 getting to the bolt, look climber’s right when you are below the bolt, and you’ll find… View Comment
Aug 31, 2025
There’s a fine line between bravery and stupidity. The top of the cliff here is quite loose. I’d highly rec… View Comment
Aug 30, 2025
Again, like I mentioned for Swine and Dine, the FA here is certainly a climber of old and not SRatch. This… View Comment

Forum Messages View All 41

General > General Climbing
Reply: 3D Printed Climbing Holds - Strength Tested
Jul 18, 2025 If you would like my paper, please shoot me an email. (Email address listed on my account.) View Message
General > General Climbing
Reply: 3D Printed Climbing Holds - Strength Tested
Jun 19, 2025 .6mm nozzle. Max layer height for the nozzle. 12 perimeters. 15% infill. All others settings default. View Message
General > General Climbing
Reply: 3D Printed Climbing Holds - Strength Tested
Mar 28, 2025 I can email you the paper. View Message
General > General Climbing
Reply: Hot Takes 2025
Mar 20, 2025 These viewpoints of mine aren’t contradictory. One can think we shouldn’t chip descent holds because one can just easily rappel and still think some other conservat… View Message
General > General Climbing
Reply: Hot Takes 2025
Mar 17, 2025 Hot takes:- Most raptor closures are way too stringent and are unnecessary. So I can’t even climb on the other side of the cliff as the nest? So even climbing remotely cl… View Message
General > General Climbing
Reply: 3D Printed Climbing Holds - Strength Tested
Feb 4, 2025 There are many studies out there about the best orientation of layer lines in a 3D printed part to maximize part strength. My experiment with climbing holds is no different. In… View Message
Welcome

Join the Community! It's FREE

Already have an account? Login to close this notice.