Type: Trad, 90 ft (27 m)
GPS: 37.87303, -119.40109
FA: Bryan Law and Linda Jarit, August 2009
Page Views: 497 total · 9/month
Shared By: Bryan Law on Sep 25, 2021
Admins: Mike Morley, Adam Stackhouse, Salamanizer Ski, Justin Johnsen, Vicki Schwantes

You & This Route


1 Opinions
Your To-Do List: Add To-Do ·
Your Star Rating:
Rating Rating Rating Rating Rating      Clear Rating
Your Difficulty Rating:
-none- Change
Your Ticks:Add New Tick
-none-
Use onX Backcountry to explore the terrain in 3D, view recent satellite imagery, and more. Now available in onX Backcountry Mobile apps! For more information see this post.
Warning Access Issue: Latest updates on closures, permits, and regulations. DetailsDrop down

Description Suggest change

Bayonet is more featured and is easier than the routes to the left.  To get to Bayonet, climb the first pitch of Incision and belay on cams at a small ledge at the base of the prominent left-facing corner (5.7, 1 lead bolt, cams 2 ea. 0.5” – 2.5”; see route page for Incision).  Then move the belay down and left along the ramp to the lower bolted anchor of Bayonet (place gear along the ramp traverse for the follower if necessary).  Another option to get to Bayonet is to climb Cut to Pieces, then rappel with two ropes to the lower bolted anchor of Bayonet.  A single 70m rope might reach the anchor but I am not sure.

From the lower bolted anchor of Bayonet, climb above the belay to a small shelf, then past three bolts to a 5.8+ crux.  Continue past three more bolts to a stance with a 2-bolt anchor with chains.  There is a little bit of a runout between the fifth and sixth bolts although the climbing is easier.  (6 lead bolts)

90-foot rappel to the lower bolted anchor, then a 100-foot rappel to the shelf at the base of the approach pitch of Cut to Pieces.  Or, one long rappel with two ropes.

Location Suggest change

Bayonet is the next bolted route to the right of Cut to Pieces, on the far-right edge of Razor Back.  It begins on the lower left end of the ramp below the Incision pitch 2 corner.  See descriptive photo.

Protection Suggest change

Minimum 6 draws for lead bolts
Cams 2 ea. 0.5” – 2.5” (for pitch 1 of Incision and belay)

Photos

loading