Mountain Project Logo
Climb
MTB
Hike
Trailrun
Ski
Limited Time70% OffonX Backcountry
Nick Weicht > Pictures Of How to bu…
Mesuer and cut the pre drilled 3/4" climbing surface then screw them to the wall with 1 3/8" sheet rock screws.
ID 109353113 · · Copyright Violation?
The insulation in the walls keeps the gym warm in the winter, cool in the summer and cuts down on noise both in and outside when fun is being had.
The right tools for the right job, If you can get a chop saw the angles will work out a lot better than using only a skill saw.<br>
Rate Photo
Rating Rating Rating Rating Rating      Clear Rating
  5.0 from 1 vote
Nick Weicht
Aug 14, 2014
“Mesuer and cut the pre drilled 3/4" climbing surface then screw them to the wall with 1 3/8" sheet rock screws.”  

0 Comments

Nearby Photos

The center line of all the studs were marked on the ground. Then I used a laser level to be sure every screw in every bracket hit the framing member it was aiming for. If you do not sheer the outside walls this task would be cheaper and essayer but you would not have as solid of a final product.
When drilling out your T-nut holes use a templet, then knock out 4 sheets at a time with a spade bit. Dipping the tip in a glass of water once for each sheet on each hole will make a drastic improvement in the life of a drill bit.
The insulation in the walls keeps the gym warm in the winter, cool in the summer and cuts down on noise both in and outside when fun is being had.
Mesuer and cut the pre drilled 3/4" climbing surface then screw them to the wall with 1 3/8" sheet rock screws.
The right tools for the right job, If you can get a chop saw the angles will work out a lot better than using only a skill saw.<br>
Flip the highway billboard sign vinyl over a few mattresses and you have a perfect crash pad.
It is best to use full sheets of plywood for many reasons. Simple, less waist, cheaper and you can always add volumes later for more variety.
The bottom place is attached to the floor with three hinges so this wall had to be framed up in place.
Angle brackets were used to frame up the wall to give each stud much move strength than toe nailing. It also made it easy to frame the wall in place due to the small size of the room. 16'x12'
T-nuts for the systems wall are on a 8"x8" pattern to allow for a great variety of setting options.
The floor turned out better than I ever emagined. 52 mattresses work like a charm.
St. Marry Man Camp bouldering session to train up for another winter in Thailand.
Welcome

Join the Community! It's FREE

Already have an account? Login to close this notice.

Get Started