adding hammer to reactor tool

hey guys i’m about add hammers to my black diamond reactors and was wondering if anyone has experience/ results with adding either the micro hammer vs the alpine hammer and which one is compatible / works the best.  

No experience with them on the Reactors but similar with Cobras. I would say to try both. Look at the head angle to see which will in general impact flat rather than at an angle. My gut says the alpine hammer is going to be better.

The micro hammer does not fit and I'm pretty sure that was what they told me and that it only fits the Cobras.  I put the alpine hammer on my reactors and it definitely changed the swing geometry.  So much that I went back to the original plate.  The tools are great but when the ice is bullet hard they have a tendency to be harder to get a deep stick.  They could definitely benefit from some pick weights but so far none are available to my knowledge.