Mountain Project Logo

Member Since
Jun 27, 2012
Last Visit: 2 hours ago
1,085 Points
Point Rank: #1,239 DetailsDrop down

More Info


Comments View All 60

Sep 11, 2023
This route is better than the ratings suggest. Full rebolt 9/9/23. Hop on it, it's worth doing! View Comment
Jul 19, 2023
It was spelled Hippocrite by the FA. And while a fun route, no where the best in the Red, not even the Zoo. View Comment
Apr 24, 2023
The climbing on the route is 3 stars, but the view and exposure is what makes the route special. I just cl… View Comment
Apr 19, 2023
Dave, you may have gone a bit too low on the start? Start was not chossy or crumbly the way I ended up doi… View Comment
Apr 18, 2023
It's possible... but I think this is just a bit further left than Chain Mail. Either way, wedge bolts are… View Comment
Mar 19, 2023
I rebolted the climb and appreciate the feedback. I actually climbed the route a couple of days ago and di… View Comment

Forum Messages View All 63

General > General Climbing
Reply: Defunct Climbing Terminology
Sep 30, 2022 Hongpoint View Message
General > Fixed Hardware: Bolts & Anchors
Reply: SS 304 vs 316 longevity
May 3, 2022 John Byrnes wrote: .... Many of them have a big enough diameter and big enough hole to allow you to thread the rope and lower-off without leaving a biner at the crux clip… View Message
General > Fixed Hardware: Bolts & Anchors
Reply: 1/2" 5-pc hanger debate
Apr 19, 2022 It is nearly impossible to over-tighten a bolt with a 6" wrench or ratchet.   That requires greater than 70 ft-lbs of torque.   I have a bolt in a piece of rock that… View Message
General > Fixed Hardware: Bolts & Anchors
Reply: 1/2" 5-pc hanger debate
Apr 12, 2022 Dustin Stephens wrote: Somewhat off-topic, but…. whatever happened to the Legacy bolt? Chris?Too expensive for us cheapos and not enough buy in I believe  View Message
General > Fixed Hardware: Bolts & Anchors
Reply: 1/2" 5-pc hanger debate
Apr 11, 2022 Yes, will correct in post.  Typing while working... my mistake. View Message
General > Fixed Hardware: Bolts & Anchors
Reply: 1/2" 5-pc hanger debate
Apr 11, 2022 The washer IS NECESSARY with a 1/2 SS CT Hanger + 1/2 5pcs to preserve the thread to sleeve length ratio and therefore the threading of the cone.   Also, I believe the hex… View Message
Welcome

Join the Community

Create your FREE account today!
Already have an account? Login to close this notice.

Get Started