Mountain Project Logo

Routes in q. Rosenstein

Center Crack TR 5.8 5b 16 VI- 15 HVS 4c
Center Zig-Zag TR 5.8 5b 16 VI- 15 HVS 4c
Left Corner to High Crack TR 5.7+ 5a 15 V+ 13 MVS 4b
Left Face TR 5.10b 6a+ 19 VII- 19 E2 5b
Left Ridge TR 5.9+ 5c 17 VI 17 E1 5a
Left of Alcove Pod TR 5.9 5c 17 VI 17 HVS 5a
Right of Alcove Pod TR 5.8+ 5b 16 VI- 15 HVS 4c
Shield, The TR 5.11a 6c 22 VII+ 22 E3 5c
Zig Pod Zag TR 5.8 5b 16 VI- 15 HVS 4c
Order Wrong? Sort Routes
Type: TR, 55 ft
FA: TR Karel Hrbacek + Ken Roberts
Page Views: 20 total · 4/month
Shared By: kenr on May 23, 2018
Admins:

You & This Route


2 Opinions

Your To-Do List:

Add To-Do · View List

Your Star Rating:


     Clear Rating

Your Difficulty Rating:


-none- Change

Your Ticks:

Add New Tick
    -none-

Description

Thoughtful outdoor moves the whole way, but not necessarily the "fun" kind.
. . . (Likely more diffucult if lack good jamming technique).

Get established on the low ramp section of the right-facing corner, then up the vertical right-facing corner almost to its top. Next a bit right up through a notch. Then aim for the roughly-vertical top crack and finish up that.

warning: The rock on and near this route has not been climbed much yet, and some of the rock is still breakable and loose -- so the belayer and other people should stand far away from underneath the climber or someone setting up top anchor.

. . . (Lots of vegetation on this rock as of 2018. Be prepared when climbing to navigate around protruding trees and branches, and dealing with holds slippery with grass, lichen, moss, dirt).

FA style + Naming of routes: For more on this - - > See the Main page for Cranberry Hollow.

Location

Start on low 18-inch-deep right facing corner below the highest cliff-top nub (with a roughly-vertical crack in it). The main corner section is about ten feet left from an 18-inch-diameter tree.

- - > See D on this Photo.

Protection

For ideas how to set up anchor for Top-Roping, see Description page for this sector Rosenstein.

Protection for trad Leading is unknown and likely inadequate.

Photos

0 Comments

More About Left Corner to High Crack

Printer-Friendly