Mountain Project Logo

Routes in Temple of Sinawava

Forbidden Corner 5.8 5b 16 VI- 15 HVS 4c A4
IdiOdyssey T 5.10 6b 20 VII- 19 E2 5b A2+
Monkeyfinger T 5.12 7b+ 27 VIII+ 26 E6 6b
Not So Secret Show, The T 5.10 6b 20 VII- 19 E2 5b A3 PG13
Pulpette, The T 5.9 5c 17 VI 17 HVS 5a
Pulpit, The 5.9 5c 17 VI 17 HVS 5a C1
Right Toilet Bowl Crack T 5.10a 6a 18 VI+ 18 E1 5a
Silverback, The T 5.12+ 7c 28 IX 27 E6 6b
Swoop Gimp or Be Dust T 5.9 5c 17 VI 17 HVS 5a C3
Tourist Crack T 5.10a 6a 18 VI+ 18 E1 5a
Unknown T 5.12- 7a+ 25 VIII+ 25 E5 6a
Unknown Left - AKA: Toilet Crack Left T 5.9+ 5c 17 VI 17 E1 5a
Wages of Sin T 5.10 6b 20 VII- 19 E2 5b A4
Wrath of Rhan, The T 5.10- 6a 18 VI+ 18 E1 5a A2+ PG13
Type: Trad, 60 ft
FA: Joede Schoeberlein and Mack Johnson
Page Views: 294 total · 20/month
Shared By: Cole Bradburn on Nov 28, 2016
Admins: Andrew Gram, Perin Blanchard, grk10vq

You & This Route


1 Opinions

Your To-Do List:

Add To-Do

Your Star Rating:


     Clear Rating

Your Difficulty Rating:


-none- Change

Your Ticks:

Add New Tick
    -none-
Seasonal Raptor Closures ***** RAIN AND WET ROCK ***** The sandstone in Zion is fragile and is very easily damaged when it is wet. Holds rip off and climbs have been and will continue to be permanently damaged due to climbers not respecting this phenomenon. After a heavy storm the rock will remain wet, sometimes for several days. PLEASE DO NOT CLIMB IN ZION during or after rain. A good rule of thumb is that if the ground near your climb is at all damp (and not powdery dry sand), then do not climb. There are many alternatives (limestone, granite, basalt, and plastic) nearby. Seasonal Raptor Closures Details

Description

Climb the east face of the tower beginning in a corner system. Move right through a bulge and pass an old bolted anchor. Then you continue up the unprotected blunt arete to the top.

Location

This is the smaller of the two towers at the Temple of Sinewava. Cross the river and hike around to the east side. One rope rappel will get you to the bottom.

Protection

One set of cams up to 3.5". A bolt and drilled pin anchor at the top.

Photos

- No Photos -
Cole Bradburn
Salt Lake City, UT
 
Cole Bradburn   Salt Lake City, UT
 
Replaced the webbing on top with a couple slings 11/26/16 Nov 28, 2016

More About The Pulpette

Printer-Friendly Guide