Mountain Project Logo

Routes in 2-Robinson

Couloir du Pissoir T 4th 1 2 I 2 M 1b
Fähndlimaa TR 5.7 5a 15 V+ 13 MVS 4b
Penn Alti TR 5.6 4c 14 V 12 S 4b
Pitone usato nelle dolomiti? T 5.6 4c 14 V 12 S 4b PG13
Robinson Ridge S 5.4 4a 12 IV 10 VD 3c PG13
Silver Fern TR 5.8+ 5b 16 VI- 15 HVS 4c
Southern Cross TR 5.8 5b 16 VI- 15 HVS 4c
z'Vieri TR 5.8 5b 16 VI- 15 HVS 4c
Unsorted Routes:
Type: Sport, 190 ft, 2 pitches
FA: Corey Todd + Ken Roberts
Page Views: 213 total · 15/month
Shared By: kenr on Nov 5, 2016
Admins: Aron Quiter, Euan Cameron, AWinters, M. Morley, Adam Stackhouse, Salamanizer suchoski, Justin Johnsen, Vicki Schwantes

You & This Route

1 Opinions

Your To-Do List:

Add To-Do

Your Star Rating:

     Clear Rating

Your Difficulty Rating:

-none- Change

Your Ticks:

Add New Tick


Climbing on a real arete, much on the crest of the ridge. A little taste of an "alpine" rock route.

Pitch 1: Start down below right from the base of the arete (or start on the arete and immediately traverse into the Right face. Up the face to join the arete, next up the arete to a small dihedral. Crux is to get past its top. Just above dihedral find 2-bolt anchor above behind flat platform. (5.4, 80 feet, 3 bolts)

Pitch 2: Then more along the crest of the ridge to a steeper section. The second crux is to get up this. Finish at obvious flat spot with a low bush and at least one bolt for belay, in addition to 2-bolt rappel anchor. (5.4, 110 feet, 2 bolts)

Optional extra: Continue up the ridge a ways (class 3+) then bear right (NW) toward summit knob with bigger view (class 3+).

descent: Three options:
a) rappel southeast from the two-bolt anchor down into the gully. A 60-meter rope will reach to below the 4th class sections of the gully, then hike on steep rugged slope (sometimes loose) to the bottom of the gully. This gully will always have some loose rock, so try to have each person clear off to a safer place away to the side while the next person makes their rappel -- and especially while pulling the rope down.

b) scramble up higher (west) until can go left (south) into the gully, then east down the gully (4th class) back to the bottom.

c) scramble up higher (west) until can go left (south) into the gully, but then instead of going down east, continue south scrambling up out of the gully, then traverse on rock to the top of the sector 1 Gastlosen rock, and use one of the descent methods (rappel or down-scramble) for that sector. This entirely avoids the gully.

Name: for Doug Robinson, who made great contributions to every aspect of Eastside Sierra climbing and backcountry skiing. So next the "Robinson question": What is the only kind to which he did not make a contribution?

. . (previous name for this route was "Mittellegi Ridge", a popular technical climbing route to the summit of the notorious Eiger mountain in central Switzerland - since the June Lake loop is sometimes called "Little Switzerland").

warning: The rock on and near this route has not been climbed much yet, and some of the rock is still breakable and loose -- so the belayer and other people should stand far away from underneath the climber.


(unlike most other routes in this sector) Start at the bottom of the obvious gully which is below the south (left) side of this sector. At the base of the arete on the north (right) side of the gully.

- - > See on this Photo
. . . . and this Photo


Pitch 1: Two-bolt top anchor, with 3 intermediate bolts for leading.
. . (As of 2017, hanger on upper bolt is loose. It cannot be tightened, because Bolt and nut will just spin together, presumable due to damaged bolt thread. But prying under hanger or under nut w 12-inch crowbar, it could not be budged).

Pitch 2: Top anchor is a single bolt with hanger and a low bush (so you can think either that the bolt is backing up the bush or the bush is backing up the bolt). There might also be a Trad placement for medium-large cam.

Rappel anchor at top of Pitch 2, composed of two bolts and hangers, linked by a chain and quick-links. There is a rappel ring which can be used to connect the 60-meter rope for making a rappel.

All the bolts (all 3/8 inch diameter) and hangers and rappel ring are 304 stainless steel (inox). The chain and quick-links are plated steel. Installed in November 2016.

Although there are bolts, this route is not really a "Sport" climb, because in many places on the route, a fall would likely result in injury. Bolt protection is provided only for the harder sequences. Where the climbing is easier, it's a long way to the next bolt.

But most of the route is less than vertical, so it would take many many bolts to make the whole route less dangerous in case of a fall. A leader could bring Trad protection to supplement the fixed bolts, but that's not going to make a big change to the basic situation.

Really the leader needs to be very solid at the route's difficulty level before starting, and be very careful not to fall. If you are not sure you can maintain mental focus and calmness in the face of exposure to serious injury on rock terrain which should be well within your climbing capability, do not try to lead this route - (instead develop the required mental focus and calmness in other more controlled contexts).

Also the follower needs to be solid in handling the less-difficult sections, because a fall in one of those sections would likely result at least in scrapes and bruises, if not worse (despite the protection of rope-belay from the leader above).

hints to beginning leaders: The exact placement of each bolt might be determined more by trying to avoid rope drag and other problems, rather than showing which way the easiest climbing goes.
Likely will be helpful to have some protection carabiners on some longer slings, rather than only on short quickdraws: to avoid rope drag.