Adventure Projects is hiring a web engineer to join us in Boulder, CO
Mountain Project Logo

Routes in Lower West Bolton

A Major T,TR 5.10- 6a 18 VI+ 18 E1 5a
A Minor T 5.10a 6a 18 VI+ 18 E1 5a
A-Sharp T,TR 5.6 4c 14 V 12 S 4b
Chalk Stops Here, The T,TR 5.10c 6b 20 VII 20 E2 5b R
Dead Babies T 5.5 4b 13 IV+ 11 MS 4a PG13
Dogzilla T,TR 5.9+ 5c 17 VI 17 E1 5a PG13
Gates of Eden T,TR 5.10b 6a+ 19 VII- 19 E2 5b R
Hailstorm T 5.10a 6a 18 VI+ 18 E1 5a R
Harvest Moon T,TR 5.7+ 5a 15 V+ 13 MVS 4b R
Hush, Mama Thrush T 5.8 5b 16 VI- 15 HVS 4c
In the Pines T 5.6 4c 14 V 12 S 4b PG13
Say Goodnight Dick T,TR 5.9 5c 17 VI 17 HVS 5a
Slip, The T 5.10 6b 20 VII- 19 E2 5b V1-2 5
Snake Skin Slab T,TR 5.6 4c 14 V 12 S 4b PG13
Steel Feathers T 5.10 6b 20 VII- 19 E2 5b R
Sticks and Stones T 5.10b 6a+ 19 VII- 19 E2 5b
Tea in the Sahara T 5.10b 6a+ 19 VII- 19 E2 5b
Wavey Good-Bye T 5.7 5a 15 V+ 13 MVS 4b
What's up, doc? T 5.9 5c 17 VI 17 HVS 5a R
Order Wrong? Sort Routes
Type: Trad, TR, 60 ft
FA: unknown
Page Views: 1,137 total · 28/month
Shared By: Connor F-M on May 27, 2015
Admins: Luc-514, Kris Fiore

You & This Route


18 Opinions

Your To-Do List:

Add To-Do · View List

Your Star Rating:


     Clear Rating

Your Difficulty Rating:


-none- Change

Your Ticks:

Add New Tick
    -none-

Description

Difficult to protect on lead, but a good beginner toprope. Follow thin cracks up the face, then left to the arete, and then back right to the face.

Location

Around the arete to the right of the A cracks. An obvious slab broken up with cracks.

Protection

Mostly small gear. Easy to eyeball from the ground as far as sizes go.

Photos

TSluiter
Holland, VT
  5.6
TSluiter   Holland, VT
  5.6
A slightly tricky 5.6, sometimes requires more thought than you would expect looking at it from the bottom.

Though the trickiest move(s) might be the first couple off the ground.

Protection is just fine for the first 2/3, then gets a little scarce as you near the top. Wander left to the edge 3/4 up to a good stance for the last decent placement. May 31, 2015

More About Snake Skin Slab

Printer-Friendly