Mountain Project Logo
To save paper & ink, use the [Hide] controls next to photos and comments so you only print what you need.

"Unnamed 5.11+" in Bloom Guide

5.11 PG13, Trad, 130 ft (39 m),  Avg: 3.1 from 9 votes
FA: unknown
Utah > Southeast Utah > Indian Creek > 4X4
Warning Access Issue: 2024 Raptor Avoidance Areas! Limited Toilet Facilities! DetailsDrop down
Warning Access Issue: RAIN, WET ROCK and RAPTOR CLOSURES: The sandstone around Moab is fragile and is very easily damaged when it is wet. Also please ask and be aware of Raptor Closures in areas such as CAT WALL and RESERVOIR WALL in Indian Creek DetailsDrop down

Description

This is a very fun and varied line with a scary start. Boulder up the fractured face and corner placing good gear. Place a piece (green Alien fits best) in a hollow flake just before busting out hard moves (with some sand) to the ledge above...A fall here could be grim! I'm not so sure about the integrity of the hollow flake.

Head up the slot and jam the fun, wavy (mostly #2 Camalot and some #1's) flake/crack. Enter the relatively easy (and protectable) squeeze chimney (#2 - #.5 Camalots). Pull through the small roof on good jams (#1 Camalots). Finish the climb through a thinning corner switch on mostly #.75 to slightly tighter jams and then an anchor. Killer!!

Location

This is about 2 routes right of Monster Truck and left of "Unnamed 5.11" with 2 bolts

Protection

Camalots: #.2 - #3, one green Alien, lots of runners (Recommendation in Bloom Guide basically spot-on), 70M rope will NOT work

Comments [Hide ALL Comments]

[Hide Comment] Agreed about the headiness of the mantle onto the ledge. There is a #1 Camalot placement that one can get that is slightly more reliable than the green Alien piece, but it's tricky to find. I also used a #4 Camalot in the squeeze chimney. Maybe I missed something, maybe it was the early September sandiness, but at the time it seemed like a necessary piece to avoid an insecure and runout part of the chimney. Still, pulling over the roof and the thin hands/stacking corner above is spectacular. Oct 29, 2011
Rob Dillon
Tamarisk Clearing
 
[Hide Comment] Anchor is due for replacement: 3/8 wedgies with SMC hangers, one of which spins. May 21, 2021