Mountain Project Logo

Rodan

5.10c, Trad, Alpine, 400 ft (121 m), 3 pitches, Grade II,  Avg: 3 from 1 vote
FA: Bradley White, Jim Shimberg, 1986
New Hampshire > Cannon Cliff > 2. Duet Area etc
Warning Access Issue: You may come across small, silver sensors that are part of a research project on weathering on Cannon. Please do not disturb them. Thanks ! More details can be found at mountainproject.com/forum/t… DetailsDrop down

Description

Under an arch until I was able to stand on top of a block wedged in the arch. 1/4" bolt protected step up from the block over the arch onto a ramp I climbed hard (5-6) to a platform below a shallow corner bolt. This hard (5-7) corner I climbed till it terminated underneath the right side of the large ceiling. Underneath the ceiling it was hard severe (5-8) while traversing below the ceiling. Halfway through the traverse it became no protection until I got in a piton above the ceiling in a crack. A lot of rope went out to clip into the piton. The piton sounded like a good placement and with no good footholds I needed to rest my arms for a while. So I used my head, the top of my head in the granite ceiling so my hands could let go of the rock. I called it a head jam. The head jam also enabled me to extend my arms left to do a hardly extreme (5-10-) to hard severe (5-8) moves until I got to 5-8) Icarus’s corner crack. After that I belayed Jim up onto Icarus. I led up Icarus’s third (5-7) corner to a grand belay ledge just right of Icarus corner. Then I continued climbing the corner till I could climb left up the slab easily (now 5-3) to Sextet. There was a rock slide that change the finish and the start. Start is now (A1) past the bolt. The corner to the finish is gone and the third pitch is (5-3).

Location

Belay at the top of Sticky Fingers move right and down away from the start of Icarus’s climb. Climb slab at bolt.

Protection

Trad. rack, old rusted pins, 2 old rusted bolts. Recommend a bolt kit and pins because it's all rusted.