Step 3: Prussik affixed to lead line and weighted. Note that I had to install an anchor point down below to anchor the prussik because the masterpoint is not weighted by the fallen leader..

All Locations > Escape the Belay prac…

Step 3: Prussik affixed to lead line and weighted. Note that I had to install an anchor point down below to anchor the prussik because the masterpoint is not weighted by the fallen leader..

Show Topo Overlay ID 111764050 ·

Flag This Photo

· Copyright Violation?

Step 0: The unweighted system.

Step 1: another shot of the anchor and weighted belay after the leader has fallen.

Rate Photo

0.0 from 0 votes

Orphaned User

Apr 9, 2016

“Step 3: Prussik affixed to lead line and weighted. Note that I had to install an anchor point down below to anchor the prussik because the masterpoint is not weighted by the fallen leader..”

0 Comments

Nearby Photos

Step 0: The unweighted system.

Step 3: Prussik affixed to lead line and weighted. Note that I had to install an anchor point down below to anchor the prussik because the masterpoint is not weighted by the fallen leader..

Step 1: another shot of the anchor and weighted belay after the leader has fallen.

Step 4: One mopre shot of the system after I have unclipped the belay.

Step 4: The munter-mule is untied, and the prussik is backed up with a bight clipped to the masterpoint with a locker. I am now free to unclip the belay device.

Step 3: Another shot of the weighted prussik. The munter-mule is still tied and clipped to the masterpoint with the red sling.

Step 2: Shot of the anchor with the munter-mule tied and clipped to masterpoint.

Step 2: Tied off munter-mule with overhand back-up. the red sling and wire gate are clipping the loop of the munter-mule to the masterpoint.

Step 1: My weighted harness & belay. (My figure 8 is poorly dressed).

Step 1: The anchor. The leader has fallen and her full weight is on my harness & belay.