Mountain Project Logo
Gregger Man > ACE
Old Metolius design from the '80s and an 8mm allen head drop-in bolt.
ID 110744550 · · Copyright Violation?
painted bolts
Apple Strudel before - welded cold shuts, carbon steel bolts, permanent cordelette.
Rate Photo
     Clear Rating
  0.0 from 0 votes
Gregger Man
Jul 13, 2015
“Old Metolius design from the '80s and an 8mm allen head drop-in bolt.”  

0 Comments

Nearby Photos

Doodad tools. Latest improvement to the spinner tool: use a 1/4" steel rivet for the stop pin. A piece of bicycle tube keeps it in place if you need to reverse the drill off the stud (the previous pin could go flying.)
The DragonCam that had been stuck for a while at the lip on the final pitch of Vertigo.<br> Still good. Put it on your Indian Creek rack.
Improved P3 anchor - Removed a huge pile of wedged tat (had to use a funkness device to get each piece out of the crack.) Replaced it with a climbing rope inside a 1" tubular webbing sheath tied in two loops. The first loop has its own forged ring and is tied with a water knot. The tails of that loop go around again with another forged ring and end in a double fisherman's knot. The webbing should protect from UV for a long while and keep more tat from appearing.
New anchor for Atom Smasher.
New 1/2" SS anchors for Sunrider
Rusty 3/8" anchors removed from Sunrider
Hardware removed from 'Laughing at the Moon', replaced with 1/2" stainless.
Wind Tower middle ledge near 'Left Out' after the trundle/sweeping.
Bolts from Quadrille and Toys for Tots. The Toys lead bolt came out with maybe a couple hundred pounds of axial force. The second lead bolt was so bent and abused that I could only funk on it and it broke.
Bolt spinner tool with 1/4" pin instead of a jam nut.<br>
Apple Strudel upgrade
Crux bolt removed from Apple Strudel.