Mountain Project Logo
Climb
MTB
Hike
Trailrun
Ski
Jason Halladay > Dungeon Stick Standar…
7.) Done! Tie in and "red point" that route!
ID 106549869 · · Copyright Violation?
6.) Navigate the carabiner's nose into the hanger. Once on target, give a sharp pull or two on the climbing rope to snap the carabiner into place and pop the rock out.
5.) With extra rope slack through the rope carabiner, gently lift The Dungeon Stick up towards the second bolt of the route of your choice.
Rate Photo
Rating Rating Rating Rating Rating      Clear Rating
  0.0 from 0 votes
Jason Halladay
Sep 20, 2009
“7.) Done! Tie in and "red point" that route! ”  

1 Comment

Sort by: Oldest Drop down
Newest Oldest Popular
loading

Nearby Photos

6.) Navigate the carabiner's nose into the hanger. Once on target, give a sharp pull or two on the climbing rope to snap the carabiner into place and pop the rock out.
7.) Done! Tie in and "red point" that route!
5.) With extra rope slack through the rope carabiner, gently lift The Dungeon Stick up towards the second bolt of the route of your choice.
4.) The Dungeon Stick has a couple of nubbins on the tip which are nice to hold the carabiner in place. Place the tip of the stick, with nubbin, up underneath where the gate pinches to the spine.
3.) With rock in place, clip climbing rope through rope carabiner. Careful not to backclip.
2.) Locate a small rock that will open the bolt-end carabiner gate pretty wide. The goal is to open the gate way wide, leave a bit of the carabiner's nose exposed and pinch off the gap where the gate meets the carabiner's spine. <br> <br> Also, note the bolt carabiner is facing left. Because of the orientation of bolt hangers, this is the optimal orientation.
1.) The Dungeon Stick. Look for it near the base of the main wall or perhaps around the corner near [[105986944]].

In This Photo
Allison Fritz
Los Alamos, New Mexico
Welcome

Join the Community

Create your FREE account today!
Already have an account? Login to close this notice.

Get Started