Login with Facebook

Member Since: Oct 21, 2010
Last Visit: Nov 3, 2012
Contact B RAD

Point Rank: # 18,021
Total Points: 5
Last Year: 0
Last 30 Days: 0
0 Compliments
How do you get points?
Areas = 15
Routes = 10
Photos = 5
Page Improvements = 3
Comments = 1

Where has B RAD been climbing?


All 29 | Routes | Areas | Photos | Page Improvements | Comments 5 | Posts 18 | Stars 4 | Ratings 2

Contributed Comments


Location: CA : San Francisco Bay : Mount St. Helena : The Bear : Mark's Moderate (5.10a R)
By: B RAD When: Jan 3, 2012

view comment >>
Comments: Runout?? Maybe the term is height dependent ;) but i didnt feel runout at all on this. I brought a few misc pieces to supplement, but couldnt be bothered to place them. The route is too fun and thought provoking!
Dirty, but very secure the whole way. Also did Theodore Roosevelt while we were up there.

Location: CA : Tahoe Vicinity : Woodfords Canyon : The Fortress : Sun Wall Area : The Perfect Lie Back (5.8)
By: B RAD When: Dec 12, 2011

view comment >>
Comments: Not quite perfect IMHO.

Needs to be longer! :D

Location: CA : Tahoe Vicinity : Phantom Spires : Upper Spire : Fear of Flying (5.9)
By: B RAD When: Oct 18, 2011

view comment >>
Comments: So Good! I got stuck for a few minutes trying to figure the crux moves, but pulled it off. Was able to squeeze a #2 in the belay, but didnt really need it. Emphasis on nuts.
Still a bit sore though..

Location: CA : Tahoe Vicinity : Phantom Spires : Upper Spire : Ginger Bread (5.7)
By: B RAD When: Feb 11, 2011

view comment >>
Comments: Can I get away without a #4 on this route? Currently i only go up to a #3 C4 and a #9 hex. Thanks!

Location: CA : San Francisco Bay : Mount St. Helena : The Bubble
By: B RAD When: Nov 14, 2010

view comment >>
Comments: Went here today, and did The Ladder before heading off to the far side. Noticed that ALOT of the hardware here is pretty hammered. alot of spinners, some loose nuts(could unthread by fingers), and all around scary anchors. Noticed most of the Far Side had shiny new ASCA hardware. Any ideas if the bubble will be receiving the same treatment? Or who can i contact about helping out with this?